ADIC DLT 7000 Spezifikationen PDF herunterladen (Seite 32)

22 Operation and Maintenance

Notes

• A small orange rectangle is visible whenever the cartridge is write-

protected (to the left).

• The orange rectangle will not be visible whenever the cartridge is write-

enabled (to the right).

• Store data cartridges in a dry, cool environment.

• Never reset or power down your computer or T5 Enclosure while a function

is in process or a tape is moving.

Loading a Data Cartridge

1. If you are planning to write data to, or erase data from, the cartridge, make sure the Write-Protect

switch on the cartridge is in the write-enabled position (all the way to the right).

Caution

A data cartridge can only be loaded when the Operate Handle LED is ON.

Do not attempt to open the Cartridge Insert/Release Handle unless this

LED is ON steady.

2. Lift up on the Cartridge Insert/Release Handle.

3. Insert the data cartridge into the slot.

4. Push the cartridge into the drive.

5. Push the Cartridge Insert/Release Handle closed. The drive will go on-line.

4 A load sequence will initiate where the Operate Handle LED will turn OFF and the Tape in Use

LED will blink while the drive moves the tape to BOT (Beginning of Tape). When the tape is at BOT,

the Tape in Use LED will turn ON steady. Additionally, one of the compression Density LEDs on the

Left Indicator Panel may be illuminated or blinking. The tape is now ready for use.

1 2 ... 27 28 29 30 31 32 33 34 35 36 37 ... 45 46

Keine Kommentare

ADIC DLT 7000 Spezifikationen Seite 32