ADIC DLT 7000 Spezifikationen PDF herunterladen (Seite 33)

Operation and Maintenance 23

Tape in Use

Whenever the Tape in Use LED (yellow) is ON steady, the tape is ready to use. When the tape is being

read, written, or rewound, Tape in Use blinks.

Use the following table to determine what is happening during cartridge use:

Right Indicator Panel

LED State Meaning

Tape in Use

ON steady

Blinks irregularly

Blinks regularly

A cartridge is loaded, but the tape is not moving. This

can mean no application is communicating with the

controller, or that the application is communicating

but is not delivering commands for tape motion.

A read or write is in progress.

Tape is loading, unloading, or rewinding.

Operate

Handle

ON and beeper sounds Tape is unloaded into the cartridge and the cartridge

can now be removed, or if the drive is unloaded, a

cartridge can now be inserted.

All LEDs Blinking An error has occurred during operation.

Removing a Data Cartridge

Caution

Remove a cartridge from the drive before turning OFF host system power.

Failure to remove a cartridge before turning OFF host system power can result

in cartridge and drive damage.

To unload a cartridge from the drive perform the following steps:

1. Push the Unload button.

4 The Tape in Use LED will blink as the tape rewinds.

Caution

A data cartridge can only be unloaded when the Operate Handle LED is ON.

Do not attempt to open the Cartridge Insert/Release Handle unless this

LED is ON steady.

2. When the Operate Handle LED is ON (and the beeper has sounded), pull the Cartridge

Insert/Release Handle open to eject the cartridge from the drive.

1 2 ... 28 29 30 31 32 33 34 35 36 37 38 ... 45 46

Keine Kommentare

ADIC DLT 7000 Spezifikationen Seite 33